Cleanflight firmware 1.14.0 motor does not work

CLEANFLIGHT FIRMWARE 1.14.0 MOTOR DOES NOT WORK MANUAL

CLEANFLIGHT FIRMWARE 1.14.0 MOTOR DOES NOT WORK MANUAL

For information about specific boards, see the board specific documentation.ДЄssuming that you have a flight controller board (hereby FC) in hand, you should first read through the manual that it came with. Bottom line: Handle the board very carefully until itвЂ™s installed on an aircraft!ДЇor an overview of the hardware Cleanflight (hereby CF) can run on, see Boards.md. If you drop or bump the controller, a big force will be applied on its accelerometers, which could potentially damage them. When the device is not yet installed to an aircraft, it has very little mass by itself. NOTE: Flight Controllers are typically equipped with accelerometers. Read the Introduction chapter for an overview of Cleanflight and how the community works.

Always exercise common sense, critical thinking and caution. At this point the document is only meant to be a helping guide, not an authoritative checklist of everything you should do to be safe and successful. We cannot guarantee the safety or success of your project. One could use RCGroups and/or the Youtube show FliteTest for this.ДISCLAIMER: This documents is a work in progress. basic controls, soldering, transmitter operation etc). A total beginner should first familiarize themselves with concepts and techniques of RC before using this (e.g. This is a step-by-step guide that can help a person that has never used Cleanflight before set up a flight controller and the aircraft around it for flight.

Cleanflight firmware 1.14.0 motor does not work